Hosted/10000066

From ATXHackerspace

Jump to: navigation, search

This tool, engineered by Danny Miller, is now working but some electrical work is required before general member use.

Caveat: It needs two dedicated outlets, one for the mill itself and another for the dust collector. Until those outlets are in place, nothing else can be running at the same time as the mill on the side of the room where it's located (near the back door). This includes the bandsaw, the SawStop, sander and other power tools. Also be mindful if other circuits are being used in the former Revolt area (the back scaffold).

This is a hosted tool. For operation training, contact Danny Miller

Specs will be here shortly.

The picture below is from the old location, while the mill was in the process of being built. (As soon as the table in front of it is cleared, look forward to a new pic!)

MillerTech CNC mill early stage.jpg